Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 834)

Brocade Mobility RFS Controller CLI Reference Guide 821
53-1003098-01
7
network-alias|noc|ntp|override-wlan|power-config|preferred-controller-group|
preferred-tunnel-controller|radius|rf-domain-manager|router|rsa-key|sensor-se
rver|
slot|spanning-tree|timezone|trustpoint|tunnel-controller|use|vrrp|
wep-shared-key-auth|service]
Parameters
None
Usage Guidelines:
The
no
command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated
Example
rfs7000-37FABE(config-device-00-04-96-4A-A7-08)#no area
rfs7000-37FABE(config-device-00-04-96-4A-A7-08)#no contact
Related Commands:
adopter-auto-provisionin
g-policy-lookup Enables the use of a centralized auto provisioning policy on this profile or device
adoption-site Sets the device’s adoption site name
alias Creates a network, VLAN, and service alias and enters its configuration mode
area Sets the name of area where the system is deployed
arp Configures ARP parameters
auto-learn-staging-confi
g Enables the automatic recognition of devices pending adoption
autoinstall Autoinstalls firmware image and configuration setup parameters
bridge Configures Ethernet Bridging parameters
cdp Operates CDP on the device
channel-list Configures channel list advertised to wireless clients
cluster Sets cluster configuration
configuration-persistenc
e Enables configuration persistence across reloads
contact Sets contact information
controller Configures controller WLAN settings
country-code Configures the two digit country code for legal operation
crypto Configures crypto settings
device-upgrade Configures device firmware upgrade settings on this device
dot1x Configures 802.1x standard authentication controls
dscp-mapping Configures IP Differentiated Services Code Point (DSCP) to 802.1p priority mapping for untagged frames
email-notification Configures e-mail notification