Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1224)

1216 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
23
Parameters
local-session-id <1-63>
Example
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-manual-session-test)#local-session-id 1
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-manual-session-test)#show context
l2tpv3 manual-session test
local-cookie size 8 200 300
local-ip-address 1.2.3.4
local-session-id 1
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-manual-session-test)#
Related Commands:
mtu
l2tpv3-manual-session-commands
Configures the Maximum Transmission Unit (MTU) size for the manual session tunnel. The MTU is
the size (in bytes) of the largest protocol data unit the layer can pass between tunnel peers in this
session. A larger MTU means processing fewer packets for the same amount of data.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
mtu <128-1460>
Parameters
mtu <128-1460>
Example
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-manual-session-test)#mtu
200
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-manual-session-test)#show context
local-session-id <1-63> Configures this manual session’s local session ID from 1 - 63. This is the pseudowire ID for the session.
This pseudowire ID is sent in a session establishment message to the L2TP peer.
no Removes the manual session’s local session ID
mtu <128-1460> Configures the MTU size for this manual session tunnel. Specify a value from 128 - 1460 bytes (default is
1460 bytes).