Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 902)

890 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
11
permit precedence <1-1000>
Usage Guidelines:
Every rule has a unique sequential precedence value. You cannot add two rules with the same
precedence. Rules are applied to packets in an increasing order of precedence. That means the
rule with precedence 1 is applied first, then the rule with precedence 2 and so on.
Example
rfs7000-37FABE(config-assoc-acl-test)# permit 11-22-33-44-66-01
11-22-33-44-66-FF precedence 170
rfs7000-37FABE(config-assoc-acl-test)# permit 11-22-33-44-67-01 precedence 180
rfs7000-37FABE(config-assoc-acl-test)#show context
association-acl-policy test
deny 11-22-33-44-55-01 11-22-33-44-55-FF precedence 150
permit 11-22-33-44-66-01 11-22-33-44-66-FF precedence 170
permit 11-22-33-44-67-01 11-22-33-44-67-01 precedence 180
rfs7000-37FABE(config-assoc-acl-test)#
Related Commands:
To add a single device, enter its MAC address in the parameter.
precedence <1-1000> Specifies a rule precedence. Rules are applied in an increasing order of precedence.
•
<1-1000> – Specify a value from 1 - 1000.
permit Adds a single device or a set of devices to the permit list
To add a set of devices, provide the MAC address range.
Specify the first MAC address of the range.
Specify the last MAC address of the range.
precedence <1-1000> Specifies a rule precedence. Rules are applied in an increasing order of precedence.
•
<1-1000> – Specify a value from 1 - 1000.
no Removes a permit rule based on its precedence