Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1282)

1274 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
meshid
meshpoint-config-instance
Configures a unique Service Set Identifier (SSID) for this meshpoint. This ID is used to uniquely
identify this meshpoint.
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
meshid
Parameters
meshid
Example
rfs7000-37FABE(config-meshpoint-test)#meshid TestingMeshPoint
rfs7000-37FABE(config-meshpoint-test)#show context
meshpoint test
description "This is an example of a meshpoint description"
meshid TestingMeshPoint
beacon-format mesh-point
control-vlan 1
allowed-vlans 1,10-16,18-23
data-rates 2.4GHz bgn
data-rates 5GHz an
security-mode none
no root
rfs7000-37FABE(config-meshpoint-test)#
Related Commands:
neighbor
meshpoint-config-instance
This command configures the inactivity time out value for neighboring devices. If a frame is not
received from the neighbor device for the configured time, then client resources are removed.
Supported in the following platforms:
meshid Configures a unique SSID for the meshpoint
The unique SSID configured for this meshpoint
NOTE: The mesh SSID is case sensitive and should not exceed 32 characters.
no Removes the SSID configured for this meshpoint