Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 648)

Brocade Mobility RFS Controller CLI Reference Guide 635
53-1003098-01
7
dot1x guest-vlan supplicant
dot1x use aaa-policy
Example
rfs7000-37FABE(config-profile-default-rfs7000)#dot1x use aaa-policy test
rfs7000-37FABE(config-profile-default-rfs7000)#dot1x system-auth-control
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
bridging-mode isolated-tunnel
ip igmp snooping
ip igmp snooping querier
......................................................
interface pppoe1
use firewall-policy default
service pm sys-restart
router ospf
dot1x system-auth-control
dot1x use aaa-policy test
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
dscp-mapping
Profile Config Commands
Configures IP Differentiated Services Code Point (DSCP) to 802.1p priority mapping for untagged
frames
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
dscp-mapping priority <0-7>
guest-vlan Configures guest VLAN and supplicant behavior
This feature is disabled by default.
supplicant Allows 802.1x capable supplicant to enter guest VLAN. When enabled, this is the VLAN that supplicant’s
traffic is bridged on.
use aaa-policy
Associates a specified 802.1x AAA policy with this access point profile
•
– Specify the AAA policy name. Once specified, this AAA policy is utilized for
authenticating user requests.
no Disables or reverts settings to their default