Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 791
778
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
no
Negates a command or resets values to their default
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
no [adopter-auto-provisioning-policy-lookup|alias|area|arp|
auto-learn-staging-config|autogen-uniqueid|autoinstall|bridge|cdp|cluster|
configuration-persistence|controller|critical-resource|crypto|device-upgrade|
dot1x|
dscp-mapping|email-notification|environmental-sensor|events|export|floor|gre|
http-analyze|interface|ip|l2tpv3|l3e-lite-table|led|led-timeout|
legacy-auto-downgrade|legacy-auto-update|lldp|load-balancing|logging|
mac-address-table|mac-auth|memory-profile|meshpoint-device|
meshpoint-monitor-interval|min-misconfiguration-recovery-time|mint|
misconfiguration-recovery-time|noc|ntp|power-config|preferred-controller-grou
p|
preferred-tunnel-controller|radius|rf-domain-manager|router|spanning-tree|
tunnel-controller|use|vrrp|wep-shared-key-auth|service]
Parameters
None
Usage Guidelines:
The no command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated
Example
rfs7000-37FABE(config-profile-default-rfs7000)#no cluster
Related Commands:
adopter-auto-provisioning-policy-l
ookup
Enables the use of a centralized auto provisioning policy on this profile
Configures network, VLAN, and service aliases on this profile
Enables adoption of Brocade Mobility 300 Access Points
Sets the area name where the system is located