Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 602
Brocade Mobility RFS Controller CLI Reference Guide
589
53-1003098-01
7
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-crypto-auto-ipsec-secure)#
The following table summarizes the crypto IPSec auto tunnel commands.
groupid
crypto-auto-ipsec-tunnel commands
Specifies the identity string used for IKE authentication
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
groupid
groupid
Parameters
Command
Description
Reference
Specifies the identity string used for IKE authentication
Enables the controller or service platform to uniquely identify APs and the hosts present in
the AP’s subnet
Configures the IKE SA’s key lifetime in seconds
Enables/disables the forced reauthentication of IKEv2 peer
Defines the IKE version used for an auto IPSec tunnel using secure gateways
Negates a command or sets its default