Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 409)

394 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
5
captive-portal Captive portal commands
crypto Encryption related commands
debug Debugging functions
logging Modify message logging facilities
page Toggle paging
service Service Commands
terminal Set terminal line parameters
wireless Wireless Configuration/Statistics commands
rfs7000-37FABE>
Related Commands:
revert
Common Commands
Reverts changes made, in the current session, to their last saved configuration
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
revert
Parameters
None
Example
rfs7000-37FABE>revert
rfs7000-37FABE>
service
Common Commands
Service commands are used to view and manage configurations. The service commands and their
corresponding parameters vary from mode to mode. The User Exec mode and Priv Exec mode
commands provide same functionalities with a few minor changes. The Global Config service
command sets the size of history files. It also enables viewing the current mode’s CLI tree.
This section consists of the following sub-sections:
no User Exec Commands mode
no Priv Exec Commands mode
no Global Config Commands mode