Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 185)

Brocade Mobility RFS Controller CLI Reference Guide 169
53-1003098-01
4
Related Commands:
br650
Global Configuration Commands
Adds an Brocade Mobility 650 Access Point to the network. If a profile for the AP is not available, a
new profile is created.
Supported in the following platforms:
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
br650
Parameters
br650
Example
rfs7000-37FABE(config)#br650 5C-0E-8B-34-81-BC
rfs7000-37FABE(config-device-5C-0E-8B-34-81-BC)#
rfs7000-37FABE(config)#show wireless br configured
-----------------------------------------------------------------------------
----------
IDX NAME MAC PROFILE RF-DOMAIN
ADOPTED-BY
-----------------------------------------------------------------------------
----------
1 br7131-889EC4 00-15-70-88-9E-C4 default-br7131 default
un-adopted
5 br650-3481BC 5C-0E-8B-34-81-BC default-br650 default
un-adopted
-----------------------------------------------------------------------------
----------
rfs7000-37FABE(config)#
Related Commands:
br6511
Global Configuration Commands
Adds an Brocade Mobility 6511 Access Point to the network. If a profile for the AP is not available, a
new profile is created.
no Removes an existing network, VLAN, service, or string alias
Specify the Brocade Mobility 650 Access Point’s MAC address.
no Removes an Brocade Mobility 650 Access Point from the network