Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 760)

Brocade Mobility RFS Controller CLI Reference Guide 747
53-1003098-01
7
ip nat [crypto source pool|pool ]
ip nat [inside|outside] destination static <1-65535> [tcp|udp]
[( {<1-65535>})]
ip nat [inside|outside] source static <1-65535> [tcp|udp]
[( {<1-65535>})]
ip nat [inside|outside] source list interface
[|pppoe1|vlan <1-4094>|wwan1] [(address |interface
|overload|
pool )]
nat Configures the NAT parameters
crypto source pool
Configures the NAT source address translation settings for IPSec tunnels
•
– Specify a NAT pool name.
pool Configures a pool of IP addresses for NAT
•
– Specify a name for the NAT pool.
nat Configures the NAT parameters
[inside|outside] Configures inside and outside address translation for the destination
•
inside – Configures inside address translation
•
outside – Configures outside address translation
destination static
The following keywords are common to the ‘inside’ and ‘outside’ parameters:
•
destination – Specifies destination address translation parameters
•
static – Specifies static NAT local to global mapping
•
– Specify the actual outside IP address to map.
<1-65535> [tcp|udp]
•
<1-65535> – Configures the actual outside port. Specify a value from 1 - 65535.
•
tcp – Configures Transmission Control Protocol (TCP) port
•
udp – Configures User Datagram Protocol (UDP) port
<1-65535> Enables configuration of the outside natted IP address
•
– Specify the outside natted IP address.
•
<1-65535> – Optional. Configures the outside natted port. Specify a value
from 1 - 65535.
nat Configures the NAT parameters
[inside|outside] Configures inside and outside address translation for the source
•
inside – Configures inside address translation
•
outside – Configures outside address translation
source static
The following keywords are common to the’ inside’ and ‘outside’ parameters:
•
source – Specifies source address translation parameters
•
static – Specifies static NAT local to global mapping
•
– Specify the actual inside IP address to map.
<1-65535> [tcp|udp]
•
<1-65535> – Configures the actual outside port. Specify a value from 1 - 65535.
•
tcp – Configures Transmission Control Protocol (TCP) port
•
udp – Configures User Datagram Protocol (UDP) port
<1-65535> Enables configuration of the outside natted IP address
•
– Specify the outside natted IP address.
•
<1-65535> – Optional. Configures the outside natted port. Specify a value
from 1 - 65535.
nat Configures the NAT parameters
[inside|outside] Configures inside and outside IP access list