Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 493)

Brocade Mobility RFS Controller CLI Reference Guide 479
53-1003098-01
6
rfs4000-229D58(config-ip-acl-auto-tunnel-acl)#show context
ip access-list auto-tunnel-acl
permit ip host 200.200.200.99 30.30.30.1/24 rule-precedence 2
permit ip host 200.200.200.99 any rule-precedence 3
rfs4000-229D58(config-ip-acl-auto-tunnel-acl)#
The following example dispalys the statistics for the ‘auto-tunnel-acl’ ACL:
rfs4000-229D58#show ip-access-list stats
IP Access-list: auto-tunnel-acl
permit ip host 200.200.200.99 30.30.30.1/24 rule-precedence 2
Hitcount: 0
permit ip host 200.200.200.99 any rule-precedence 3 Hitcount: 0
rfs4000-229D58#
nx6524-5483B0#show ip-access-list stats scaleacl | i 125
permit ip host 125.1.1.1 any rule-precedence 125 Hitcount: 893
Hardware Hitcount: 3120
permit ip host 125.2.1.1 any rule-precedence 346 Hitcount: 0
Hardware Hitcount: 0
nx6524-5483B0#
l2tpv3
show commands
Displays a Layer 2 Tunnel Protocol Version 3 (L2TPV3) session information
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
l2tpv3 {on|tunnel|tunnel-summary}
l2tpv3 {on }
l2tpv3 {tunnel } {session }
{(on )}
l2tpv3 {tunnel-summary} {down|on|up}
l2tpv3 {tunnel-summary} {on }
l2tpv3 {tunnel-summary} {down|up} {on }
Parameters