Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 528)

514 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show upgrade-status {detail|on}
show upgrade-status {detail} {(on )}
Parameters
show upgrade-status {detail} {(on )}
Example
rfs4000-229D58(config)#show upgrade-status on rfs4000-229D58
Last Image Upgrade Status : Successful
Last Image Upgrade Time : 2013-04-10 09:10:05
rfs4000-229D58(config)#
rfs4000-229D58(config)#show upgrade-status detail on rfs4000-229D58
Last Image Upgrade Status : Successful
Last Image Upgrade Time : 2013-04-10 09:10:05
-----------------------------------------------
Running from partition /dev/mtdblock7
var2 is 3 percent full
/tmp is 5 percent full
Free Memory 114440 kB
FWU invoked via Linux shell
Validating image file header
Making file system
Extracting files (this may take some time).
Control C disabled
Version of firmware update file is 5.5.0.0-034B
Writing Kernel to /dev/mtd4
Writing BootOS to /dev/mtd2
Successful
rfs4000-229D58(config)#
version
show commands
Displays a device’s software and hardware version
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
upgrade-status Displays last image upgrade status and log
detail Optional. Displays last image upgrade status in detail
on The following keyword is recursive and common to the ‘detail’ parameter:
•
on – Optional. Displays last image upgrade status on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.