Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 256)

240 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
diag Configures diagnostics module related event messages
•
autogen-tech-sprt – Event autogen technical support message
•
buf-usage – Event buffer usage message
•
cpu-load – Event CPU load message
•
cpu-usage-too-high – Event CPU usage high message
•
cpu-usage-too-high-recovery – Event recovery from high CPU usage message
•
disk-usage – Event disk usage message
•
elapsed-time – Event elapsed time message
•
fan-underspeed – Event fan underspeed message
•
fd-count – Event forward count message
•
free-flash-disk – Event free flash disk message
•
free-flash-inodes – Event free flash inodes message
•
free-nvram-disk – Event free nvram disk message
•
free-nvram-inodes – Event free nvram inodes message
•
free-ram – Event free ram message
•
free-ram-disk – Event free ram disk message
•
free-ram-inodes – Event free ram inodes message
•
head-cache-usage – Event head cache usage message
•
high-temp – Event high temp message
•
ip-dest-usage – Event ip destination usage message
•
led-identify – Event led identify message
•
low-temp – Event low temp message
•
mem-usage-too-high – Event memory usage high message
•
mem-usage-too-high-recovery – Event recovery from high memory usage message
•
new-led-state – Event new led state message
•
over-temp – Event over temp message
•
over-voltage – Event over voltage message
•
poe-init-fail – Event PoE init fail message
•
poe-power-level – Event PoE power level message
•
poe-read-fail – Event PoE read fail message
•
poe-state-change – Event PoE state change message
Contd..
•
poe-state-change – Event PoE state change message
•
pwrsply-fail – Event failure of power supply message
•
raid-degraded – Event Redundant Array of Independent Disks (RAID) degraded message
•
raid-error – Event RAID error message
•
ram-usage – Event ram usage message
•
under-voltage – Event under voltage message
•
wd-reset-sys – Event wd reset system message
•
wd-state-change – Event wd state change message