Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 835
822
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Checks the device firmware version before attempting connection
Configures the environmental sensor device settings. If the device is an environmental sensor, use this
command to configures its settings,
Displays system event messages
Enables export of startup.log file after every boot
Sets the building floor where the system is deployed
Configures the geographic coordinates for this device
Enables GRE tunneling on this profile
Sets a system's network name
Enables HTTP analysis on this device
Selects an interface to configure
Configures IP components
Defines the L2TP protocol for tunneling layer 2 payloads using VPNs
Configures L3e lite table aging time
Configures layout coordinates
Turns LEDs on or off
Enables legacy device firmware to auto downgrade
Auto updates Brocade Mobility 650 Access Point and Brocade Mobility 71XX Access Point legacy device
firmware
Configures LLDP settings for this profile
Configures load balancing parameters
Configures the location the system is deployed
Enables message logging
Configures the MAC address table
Enables 802.1x authentication of hosts on this device
Configures MAC name to name mappings
Configures device’s memory profile
Configures device’s meshpoint parameters
Configures meshpoint monitoring interval on the device
min-misconfiguration-re
covery-time
Configures the minimum connectivity verification time
Configures MiNT protocol commands
misconfiguration-recove
ry-time
Verifies connectivity after a device configuration is received
Configures a neighbor inactivity timeout
Configures the neighbor information exchange interval
Configures NOC settings
Configure the NTP server settings