Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1223)

Brocade Mobility RFS Controller CLI Reference Guide 1215
53-1003098-01
23
Configures the manual session’s source IP address. If no IP address is specified, the tunnel’s
source IP address is automatically configured based on the tunnel peer IP address. This parameter
is applicable when establishing the session and responding to incoming requests.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
local-ip-address
Parameters
local-ip-address
Example
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-manual-session-test#local-ip-address 1.2.3.4
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-manual-session-test)#show context
l2tpv3 manual-session test
local-cookie size 8 200 300
local-ip-address 1.2.3.4
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-manual-session-test)#
Related Commands:
local-session-id
l2tpv3-manual-session-commands
Configures the manual session’s local session ID
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
local-session-id <1-63>
local-ip-address Configures the manual session’s source IP address in the A.B.C.D format
no Resets the manual session’s local source IP address. This re-establishes the session.