Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1142)

1134 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
20
Syntax:
group-by [area|floor]
Parameters
group-by [area|floor]
Example
rfs7000-37FABE(config-smart-rf-policy-test)#group-by floor
rfs7000-37FABE(config-smart-rf-policy-test)#show context
smart-rf-policy test
area test channel-list 2.4GHz 1,2,3
group-by floor
sensitivity custom
assignable-power 5GHz min 8
assignable-power 5GHz max 20
channel-list 2.4GHz 1,12
channel-width 5GHz auto
coverage-hole-recovery snr-threshold 5GHz 1
rfs7000-37FABE(config-smart-rf-policy-test)#
Related Commands:
interference-recovery
smart-rf-policy
Enables interference recovery from neighboring radios and other sources of WiFi and non-WiFi
interference. Interference is the excess noise detected within the Smart RF supported radio
coverage area. Smart RF provides mitigation from interfering sources by monitoring the noise levels
and other RF parameters on an access point radio’s current channel. When a noise threshold is
exceeded, Smart RF selects an alternative channel with less interference. To avoid channel
flapping a hold timer is defined, which disables interference avoidance for a specific period of time
upon detection. Interference recovery is enabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
area Groups radios based on their area of location
floor Groups radios based on their floor location
Both options are disabled by default.
no Removes Smart RF group settings