Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 76)

58 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
2
no service locator {on }
no terminal [length|width]
no virtual-machine assign-usb-ports {on }
no wireless client all {filter [wlan ]}
no wireless client all {on } {filter [wlan
]}
no wireless client mac {on }
Usage Guidelines:
The
no
command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Example
rfs7000-37FABE>no adoption
rfs7000-37FABE>no page
rfs7000-37FABE>no service cli-tables-expand line
no service Disables LEDs on a specified device or all devices in the WLAN. It also resets the CLI table expand and
MiNT protocol configurations.
locator
{on } Disables LEDs on a specified device
•
on – Optional. Specify the name of the AP, wireless controller, or service platform.
If no device name is specified, the system disables LEDs on all devices in the WLAN.
no terminal [length|width] Resets the width of the terminal window or the number of lines displayed within the terminal window
•
length – Resets the number of lines displayed on the terminal window to its default
•
width – Resets the width of the terminal window to its default
no virtual-machine
assign-usb-ports Reverts ports assigned for virtual-machines back to Mobility
This command is available only on the Brocade Mobility RFS9510 series service platforms.
on Reverts virtual-machine assigned ports on a specified device
•
on – Optional. Specify the name of the AP, wireless controller, or service platform.
no wireless client all Disassociates all clients on a specified device or domain
filter
[wlan ] Optional. Specifies additional client selection filter
•
wlan – Filters clients on a specified WLAN
•
– Specify the WLAN name.
no wireless client all
{on
} Disassociates all wireless clients on a specified device or domain
•
on – Optional. Specify the name of the AP, wireless controller, service
platform, or RF Domain.
filter
[wlan ] The following are optional filter parameters:
•
filter – Optional. Specifies additional client selection filter
•
wlan – Filters clients on a specified WLAN
•
– Specify the WLAN name.
no wireless client
mac Disassociates a single wireless client on a specified device or RF Domain
•
mac – Specify the wireless client’s MAC address in the AA-BB-CC-DD-EE-FF format.
on
Optional. Specifies the name of the AP, wireless controller, service platform, or RF Domain to which the
specified client is associated