Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 583)

570 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
stateful-packet-inspection-l2
Parameters
None
Example
rfs7000-37FABE(config-profile
default-rfs7000-bridge-vlan-1)#stateful-packet-ins
inspection-l2
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#
Related Commands:
tunnel
bridge-vlan-mode commands
Enables tunneling of unicast messages, to unknown MAC destinations, on the selected VLAN
bridge
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
tunnel unknown-unicast
Parameters
None
Example
rfs7000-37FABE(config-profile TestAP81xx-bridge-vlan-1)#tunnel
unknown-unicast
rfs7000-37FABE(config-profile TestAP81xx-bridge-vlan-1)#
no Disables stateful packet inspection at the layer 2 firewall