Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 424)

Brocade Mobility RFS Controller CLI Reference Guide 409
53-1003098-01
5
service smart-rf [clear-history|interactive-calibration|run-calibration|
save-config|stop-calibration] {on }
service smart-rf interactive-calibration-result
[discard|replace-current-config|
write-to-configuration] {on }
service ssm dump-core-snapshot
service ssm trace pattern {on }
service wireless client beacon-request mode [active|passive|table]
ssid [|any] channel-report [|none] {on }
Optional. Clears WLAN Smart RF configuration on a device identified by its MAC address. Specify the
device’s MAC address in the AA-BB-CC-DD-EE-FF format.
Optional. Clears WLAN Smart RF configuration on a device identified by its hostname. Specify the device’s
hostname.
on Optional. Clears WLAN Smart RF configuration on all devices in a specified RF Domain
•
– Specify the RF Domain name.
smart-rf Enables Smart RF management
clear-history Clears WLAN Smart RF history on all devices
interactive-calibration Enables an interactive Smart RF calibration
run-calibration Starts a new Smart RF calibration process
save-config Saves the Smart RF configuration on all devices, and also saves the history on the RF Domain Manager
stop-calibration Stops an in-progress Smart RF calibration
on Optional. Clears WLAN Smart RF configuration on all devices in a specified RF Domain
•
– Specify the RF Domain name.
smart-rf Enables Smart RF management
interactive-calibration-result Displays interactive Smart RF calibration results
discard Discards interactive Smart RF calibration results
replace-current-config Replaces current radio configuration
write-to-configuration Writes and saves radio settings to configuration
on Optional. Displays interactive Smart RF calibration results on a specified RF Domain
•
– Specify the RF Domain name.
ssm
dump-core-snapshot Triggers a debug core dump of the SSM module
ssm trace Displays the SSM module trace based on parameters passed
pattern Configures the pattern to match
•
– Specify the pattern to match.
on Optional. Displays the SSM module trace on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.
wireless client
beacon-requests Sends beacon measurement requests to a wireless client
Specify the wireless client’s MAC address.