Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1246)

1238 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
24
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
router-id
Parameters
router-id
Example
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#router-id
172.16.10.8
Reload, or execute "clear ip ospf process" command, for this to take effect
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
Related Commands:
vrrp-state-check
router-mode
Publishes interface via OSPF based on Virtual Router Redundancy Protocol (VRRP) status
VRRP provides automatic assignments of available IP routers to participating hosts. This increases
the availability and reliability of routing paths via automatic default gateway selections on an IP
subnetwork. This option is enabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
vrrp-state-check
Parameters
Identifies the OSPF router by its IP address
•
– Specify the router ID in the IP format
no Removes the configured OSPF router ID