Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 668
Brocade Mobility RFS Controller CLI Reference Guide
655
53-1003098-01
7
Usage Guidelines:
The ports available on a device vary depending on the model. The following ports are available on
Brocade Mobility RFS4000, Brocade Mobility RFS6000 and Brocade Mobility RFS7000 model
wireless controllers:
Brocade Mobility RFS4000 - ge1, ge2, ge3, ge4, ge5, up1
Brocade Mobility RFS6000 - ge1, ge2, ge3, ge4, ge5, ge6, ge7, ge8, me1, up1
Brocade Mobility RFS7000 - ge1, ge2, ge3, ge4, me1
The ports available on service platforms also vary depending on the model.
GE ports are available on Brocade Mobility RFS4000, Brocade Mobility RFS6000 and Brocade
Mobility RFS7000 controllers. GE ports are RJ-45 supporting 10/100/1000Mbps. GE ports on the
Brocade Mobility RFS7000 can be RJ-45 or fiber ports supporting 10/100/1000Mbps.
ME ports are available on Brocade Mobility RFS6000 and Brocade Mobility RFS7000 platforms.
ME ports are out-of-band management ports used to manage the controller via CLI or Web UI, even
when the other ports on the controller are unreachable.
UP ports are available on Brocade Mobility RFS4000 and Brocade Mobility RFS6000 platforms. A
UP port is used to connect to the backbone network. UP ports are available on Brocade Mobility
RFS4000 and Brocade Mobility RFS6000 controllers. A UP port supports either RJ-45 or fiber. The
UP port is the preferred means to connect to the backbone as it has a non-blocking 1gbps
connection unlike the GE ports.
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan44)#
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan44)#?
SVI configuration commands:
crypto Encryption module
description Vlan description
dhcp-relay-incoming Allow on-board DHCP server to respond to relayed DHCP
packets on this interface
ip Interface Internet Protocol config commands
no Negate a command or set its defaults
shutdown Shutdown the selected interface
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan44)#
nx4500-5CFA2B(config-profile-testNX45XX)#interface vmif 2
nx4500-5CFA2B(config-profile-testNX45XX-if-vmif12)#
nx4500-5CFA2B(config-profile-testNX45XX-if-vmif2)#?
VM Interface Mode commands:
description Port description