Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 80)

62 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
2
Brocade Mobility RFS4000 release 5.5.0.0-018D
rfs4000-229D58 login:
terminal
User Exec Commands
Sets the length or the number of lines displayed within the terminal window
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
terminal [length|width] <0-512>
Parameters
terminal [length|width] <0-512>
Example
rfs7000-37FABE>terminal length 150
rfs7000-37FABE>terminal width 215
rfs7000-37FABE>show terminal
Terminal Type: xterm
Length: 150 Width: 215
rfs7000-37FABE>
Related Commands:
time-it
User Exec Commands
Verifies the time taken by a particular command between request and response
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
length <0-512> Sets the number of lines displayed on a terminal window
•
<0-512> – Specify a value from 0 - 512.
width <0-512> Sets the width (the number of characters displayed) of the terminal window
•
<0-512> – Specify a value from 0 - 512.
no Resets the width and length of the terminal window