Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1300)

1292 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
br7131-139B34(config-device-00-23-68-13-9B-34-meshpoint-test)#?
meshpoint-device-commands
meshpoint-device-config-instance
The following table lists the meshpoint-device configuration mode commands
acs
meshpoint-device-commands
Enables Automatic Channel Selection (ACS) on this meshpoint device (access point). When
enabled, this feature automatically selects the best channel for a meshpoint-device radio based on
the device configuration, channel conditions, and network layout.
In a wireless network deployment, it is advantageous for network devices to have the ability to
operate in multiple channels and not be limited to only a single channel. Multiple channels
increase the bandwidth and throughput of the wireless network. In such a scenario, each network
device must have a mechanism to dynamically select a suitable channel of operation. ACS provides
the required mechanism for a MCX enabled device.
Use this command to configure the ACS settings and override the default meshpoint
configurations.
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
Syntax:
Command Description Reference
acs Enables Automatic Channel Selection (ACS) on this meshpoint device (access
point) page 1292
exclude Excludes neighboring mesh devices page 1296
hysteresis Configures path selection SNR hysteresis values on this meshpoint-device (access
point) page 1297
monitor Enables monitoring of critical resource and primary port links on a meshpoint
device page 1298
path-method Configures the method used to select the path to the root node in a mesh network page 1298
preferred Configures the preferred path parameters for a meshpoint device page 1299
root Configures a meshpoint device as the root meshpoint page 1300
root-select Configures this meshpoint device as the cost root page 1301
no Negates the commands for a meshpoint device or resets values to default page 1302