Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 667)

654 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax: Service Platforms
interface [|fe <1-4>|ge <1-24>|me1|port-channel <1-4>|pppoe1|
radio [1|2|3]|serial <1-4>|t1e1 <1-4>|up <1-2>|vlan <1-4094>|vmif
<1-8>|wwan1|
xge <1-4>]
Syntax: Access Points and Wireless Controllers
interface [|fe <1-4>|ge <1-8>|me1|port-channel <1-4>|pppoe1|
radio [1|2|3]|up1|vlan <1-4094>|wwan1|xge <1-4>]
Parameters
interface [|fe <1-4>|fr <1-4>|ge <1-8>|me1|port-channel <1-4>|
radio [1|2|3]|serial <1-4>|t1e1 <1-4>|up1|vlan <1-4094>|vmif <1-8>|wwan1|xge
<1-4>]
Enters the configuration mode of the interface identified by the keyword
fe <1-4> Selects a FastEthernet interface
•
<1-4> – Specify the interface index from 1 - 4.
This interface is applicable only for Brocade Mobility 6511 Access Point
ge <1-8> Selects a GigabitEthernet interface
•
<1-8> – Specify the interface index from 1 - 8. (4 for Brocade Mobility RFS7000 and 8 for Brocade
Mobility RFS6000).
me1 Selects a management interface
Not applicable for Brocade Mobility RFS4000
The management interface is applicable only for Brocade Mobility RFS6000 and Brocade Mobility
RFS7000
port-channel <1-4> Selects the port channel interface
•
<1-4> – Specify the interface index from 1 - 4.
pppoe1 Selects the PPP over Ethernet interface to configure
radio [1|2|3] Selects a radio interface
•
1 – Selects radio interface 1
•
2 – Selects radio interface 2
•
3 – Selects radio interface 3
The radio interface is not available on wireless controllers (exception RFS4011) or service platforms.
serial <1-4> Selects a serial interface
•
<1-4> – Specify the interface index from 1 - 4.
up1 Selects the uplink GigabitEthernet interface
vlan <1-4094> Selects a VLAN interface
•
<1-4094> – Specify the SVI VLAN ID from 1 - 4094.
wwan1 Selects a Wireless WAN interface
This interface is applicable only to Brocade Mobility 71XX Access Point, Brocade Mobility 1240 Access
Point, AP82XX, Brocade Mobility RFS4000, Brocade Mobility RFS6000
xge <1-4> Selects a TenGigabitEthernet interface
•
<1-2> – Specify the interface index from 1 - 4.