Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 574)

Brocade Mobility RFS Controller CLI Reference Guide 561
53-1003098-01
7
Syntax:
bridging-mode [auto|isolated-tunnel|local|tunnel]
Parameters
bridging-mode [auto|isolated-tunnel|local|tunnel]
Usage Guidelines:
ACLs can only be used with tunnel or isolated-tunnel modes. They do not work with the local and
automatic modes.
Example
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#bridging-mode
isolated-tunnel
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#show context
bridge vlan 1
bridging-mode isolated-tunnel
ip igmp snooping
ip igmp snooping querier
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#
Related Commands:
description
bridge-vlan-mode commands
Configures VLAN bridge description
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
bridging-mode Configures the VLAN bridging modes
auto Automatically selects the bridging mode to match the WLAN, VLAN and bridging mode configurations
(default setting)
isolated-tunnel Bridges packets between local Ethernet ports and local radios, and passes tunneled packets through
without de-tunneling
Select this option for a dedicated tunnel for bridging VLAN traffic.
local Bridges packets normally between local Ethernet ports and local radios (if any)
Local mode is typically configured in remote branch offices where traffic on remote private LAN segments
need to be bridged locally. Local mode implies that traffic, wired and wireless, are to be bridged locally.
tunnel Bridges packets between local Ethernet ports, local radios, and tunnels to other APs, wireless controllers,
or service platforms
Select this option to use a shared tunnel for bridging VLAN traffic.
In tunnel mode, the traffic at the AP is always forwarded through the best path. The APs decide the best
path to reach the destination and forward packets accordingly. Setting the VLAN to tunnel mode ensures
packets are bridged between local Ethernet ports, any local radios, and tunnels to other APs, wireless
controllers, and service platforms.
no Resets bridging mode to auto