Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 952)

Brocade Mobility RFS Controller CLI Reference Guide 941
53-1003098-01
13
ddns multiple-user-class
ddns server [|] {|}
ddns ttl <1-864000>
Example
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#ddns domainname WID
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#ddns
multiple-user-class
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#ddns server
192.168.13.9
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#show context
dhcp-pool testPool
address 192.168.13.4 class dhcpclass1
ddns server 192.168.13.9
ddns domainname WID
ddns multiple-user-class
bootfile test.txt
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#
Related Commands:
default-router
dhcp-pool-mode commands
Configures a default router or gateway IP address for a network pool
After a DHCP client has booted, the client begins sending packets to its default router. Set the IP
address of one or a group of routers the controller uses to map host names into IP addresses
available to DHCP supported clients. Up to 8 default router IP addresses are supported.
multiple-user-class Enables the multiple user class options with this DDNS domain
server Configures the DDNS server used by this DHCP profile
[|] Configures the primary DDNS server. This is the default server.
Use one of the following options to specify the primary DDNS server:
•
– Specifies the primary DDNS server’s IP address
•
– Specifies a host alias, mapped to the primary DDNS server’s IP address.
The host alias should be existing and configured.
A network host alias maps a name to a single network host. For example, ‘alias host $HOST 1.1.1.100’. In
this example the host alias is ‘$HOST’ and it maps to a single host ‘1.1.1.100’. For more information, see
alias .
{|>} Optional. Configures the secondary DDNS server. If the primary server is not reachable, this server is
used.
Use one of the following options to identify the secondary DDNS server:
•
– Specifies the secondary DDNS server’s IP address
•
– Specifies a host alias, mapped to the secondary DDNS server’s IP address.
The host alias should be existing and configured.
ttl <1-864000> Configures the Time To Live (TTL) value for DDNS updates
•
<1-86400> – Specify a value from 1- 864000 seconds.
no Resets or disables a DHCP pool’s DDNS settings