Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 573)

560 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#
bridge-vlan-mode commands
bridge
The following table summarizes bridge VLAN configuration mode commands.
bridging-mode
bridge-vlan-mode commands
Configures how packets are bridged on the selected VLAN
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — , Brocade Mobility RFS9510
Command Description Reference
bridging-mode Configures how packets on this VLAN are bridged page 7-560
description Configures VLAN bridge description page 561
edge-vlan Enables edge VLAN mode page 562
firewall Enables VLAN fire wall page 7-563
ip Configures IP components page 563
l2-tunnel-broadcast-opti
mization Enables broadcast optimization page 566
no Negates a command or reverts settings to their default page 567
stateful-packet-inspectio
n-l2 Enables statedly packet inspection in the layer 2 fire wall page 569
tunnel Enables tunneling of unicast messages to unknown MAC destinations, on the selected
VLAN bridge page 570
tunnel-over-level2 Enables extended VLAN traffic over level 2 MiNT links page 571
use Uses pre configured access lists with this PF bridge policy page 572
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug (config-if) instance configurations page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425