Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 687)

674 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
spanning-tree force-version 1
spanning-tree guard root
spanning-tree mst 2 port-priority 10
dot1x supplicant username Bob password 0 motorolasolutions@123
ip dhcp trust
ip arp header-mismatch-validation
qos trust dscp
qos trust 802.1p
channel-group 1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
Related Commands:
use
interface-config-instance
Specifies the IP access list and MAC access list used with this interface
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
use [ip-access-list in |mac-access-list in
]
Parameters
use [ip-access-list in |mac-access-list in
]
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#use mac-access-list in
test
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#show context
interface ge1
description This\ is\ GigabitEthernet\ interface\ for\ Royal\ King
speed 10
duplex full
no Disables or reverts interface settings to their default
ip-access-list in
Uses an IP access list
•
in – Applies an ACL on incoming packets
•
– Specify the IP access list name (it should be an existing and
configured).
mac-access-list in
Uses a MAC access list
•
in – Applies an ACL on incoming packets
•
– Specify the MAC access list name (it should be an existing and
configured).