Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1291)

Brocade Mobility RFS Controller CLI Reference Guide 1283
53-1003098-01
27
wpa2 key-rotation [broadcast|unicast] <30-86400>
wpa2 psk [0 |2 |]
Example
rfs7000-37FABE(config-meshpoint-test)#wpa2 key-rotation broadcast 600
rfs7000-37FABE(config-meshpoint-test)#wpa2 key-rotation unicast 1200
rfs7000-37FABE(config-meshpoint-test)#wpa2 psk MotorolaSolutions
rfs7000-37FABE(config-meshpoint-test)#show context
meshpoint test
description "This is an example of a meshpoint description"
meshid TestingMeshPoint
shutdown
beacon-format mesh-point
control-vlan 1
allowed-vlans 1,10-16,18-23
neighbor inactivity-timeout 300
data-rates 2.4GHz bgn
data-rates 5GHz an
security-mode psk
wpa2 psk 0 MotorolaSolutions
wpa2 key-rotation unicast 1200
wpa2 key-rotation broadcast 600
root
rfs7000-37FABE(config-meshpoint-test)#
Related Commands:
meshpoint-qos-policy-config-instance
MESHPOINT
Mesh Quality of Service (QoS) provides a data traffic prioritization scheme. QoS reduces
congestion from excessive traffic. If there is enough bandwidth for all users and applications
(unlikely because excessive bandwidth comes at a very high cost), then applying QoS has very little
value. QoS provides policy enforcement for mission-critical applications and/or users that have
critical bandwidth requirements when bandwidth is shared by different users and applications.
wpa2 key-rotation Configures WPA2 key rotation settings
broadcast Configures key rotation interval for broadcast packets
When enabled, the key indices used for encrypting/decrypting broadcast traffic is alternatively rotated
based on the defined interval. Key rotation enhances the broadcast traffic security on the WLAN.
unicast Configures key rotation interval for unicast packets
<30-86400> Configures key rotation interval from 30 - 86400 seconds for unicast or broadcast transmission
wpa2 psk Configures the PSK used by this meshpoint
secret [0 |
2 |] Configures the PSK used to authenticate this meshpoint with other meshpoints in the network
•
0 – Configures a clear text secret
•
2 – Configures an encrypted secret
•
– Specify the secret key. The shared key should not exceed 127 characters.
no Resets PSK configuration and key rotation duration