Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 732)

Brocade Mobility RFS Controller CLI Reference Guide 719
53-1003098-01
7
Parameters
None
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#preamble-short
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
power 12
data-rates b-only
placement outdoor
mesh client
off-channel-scan channel-list 2.4GHz 1
preamble-short
guard-interval long
aggregation ampdu tx-only
aeroscout forward
ekahau forward ip 172.16.10.1 port 3
non-unicast tx-rate bss 1 dynamic-all
non-unicast tx-rate bss 2 highest-basic
non-unicast tx-rate bss 3 highest-basic
non-unicast tx-rate bss 4 highest-basic
non-unicast tx-rate bss 5 highest-basic
non-unicast tx-rate bss 6 highest-basic
non-unicast tx-rate bss 7 highest-basic
non-unicast tx-rate bss 8 highest-basic
non-unicast tx-rate bss 9 highest-basic
non-unicast tx-rate bss 10 highest-basic
non-unicast tx-rate bss 11 highest-basic
non-unicast tx-rate bss 12 highest-basic
--More--
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
probe-response
interface-config-radio-instance
Configures transmission parameters for probe response frames
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
probe-response [rate|retry]
probe-response rate [follow-probe-request|highest-basic|lowest-basic]
Parameters
no Disables the use of short preamble on a radio