Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 329)

Brocade Mobility RFS Controller CLI Reference Guide 313
53-1003098-01
4
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
self
Parameters
None
Example
rfs7000-37FABE(config)#self
rfs7000-37FABE(config-device-00-15-70-37-FA-BE)#
smart-rf-policy
Global Configuration Commands
Configures a Smart RF policy
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
smart-rf-policy
Parameters
smart-rf-policy
Example
rfs7000-37FABE(config)#smart-rf-policy test
rfs7000-37FABE(config-smart-rf-policy-test)#?
Smart RF Mode commands:
area Specify channel list/ power for an area
assignable-power Specify the assignable power during power-assignment
channel-list Select channel list for smart-rf
channel-width Select channel width for smart-rf
coverage-hole-recovery Recover from coverage hole
enable Enable this smart-rf policy
group-by Configure grouping parameters
>
Specify the Smart RF policy name. If the policy does not exist, it is created.