Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 713)

700 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#data-rates b-only
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
channel 1
data-rates b-only
beacon period 50
beacon dtim-period bss 1 5
beacon dtim-period bss 2 2
beacon dtim-period bss 3 5
........................................................
beacon dtim-period bss 13 5
beacon dtim-period bss 14 5
beacon dtim-period bss 15 5
beacon dtim-period bss 16 5
antenna-gain 12.0
aggregation ampdu tx-only
aeroscout forward
--More--
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
description
interface-config-radio-instance
Configures the selected radio’s description
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
description
Parameters
description
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#description "Primary
radio to use"
8 78 86.7 162 180 351 390
9 N/A N/A 180 200 390 433.3
MCS Index 20 MHz No SGI 20 MHz With SGI 40 MHz No SGI 40 MHz With SGI 80 MHz No SGI 80 MHz No SGI
no Resets the 802.11 data rates on a radio
rf-mode Configures the radio’s RF mode of operation
Defines a description for the selected radio (should not exceed 64 characters in length)