Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1286)

1278 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
Related Commands:
root
meshpoint-config-instance
Configures this meshpoint as the root meshpoint. Root meshpoints are generally tied to an
Ethernet backhaul for wired connectivity.
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
root
Parameters
root
Example
rfs7000-37FABE(config-meshpoint-test)#root
rfs7000-37FABE(config-meshpoint-test)#show context
meshpoint test
description "This is an example of a meshpoint description"
meshid TestingMeshPoint
beacon-format mesh-point
control-vlan 1
allowed-vlans Configures the VLANs allowed on the meshpoint
beacon-format Configures the beacon format for the meshpoint AP
control-vlan Configures the VLAN on which meshpoint control traffic traverses
data-rates Configures the data rates supported per frequency band
description Configures a human friendly description for this meshpoint
meshid Configures a unique ID for this meshpoint
neighbor Configures the neighbor inactivity time out for this meshpoint
root Configures a meshpoint as the root meshpoint
security-mode Configures the security mode to use on the meshpoint
service Allows only 802.11n capable neighbors to create a mesh connection
shutdown Shuts down the meshpoint
use Configures using a QoS policy along with this meshpoint
wpa2 Configures WPA2 encryption settings
root {auto-mint} Configures this meshpoint as the root meshpoint