Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1021)

1012 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
15
Configures the priority for MiNT router packets (HELLO, LSP, PSNP, and EXTVLAN)
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
router packet priority <0-7>
Parameters
router packet priority <0-7>
Example
rfs4000-229D58(config-mint-policy-global-default)#router packet priority 4
rfs4000-229D58(config-mint-policy-global-default)#show context
mint-policy global-default
router packet priority 4
rfs4000-229D58(config-mint-policy-global-default)#
Related Commands:
udp
mint-policy
Configures MiNT UDP/IP encapsulation parameters. Use this command to configure the default
UDP port used for MiNT control packet encapsulation.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
udp port <2-65534>
Parameters
router packet priority
<0-7> Allows you to configure the priority for MiNT router packets from 0 - 7. The default is 5.
Higher the value higher is the priority. Therefore, seven (7) represents highest priority.
no Reverts the MiNT router packet priority to default (5)