Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1310)

1302 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
Syntax:
root-select cost-root
Parameters
root-select cost-root
Example
ap7131-11E6C4(config-device-00-23-68-11-E6-C4-meshpoint-test)#root-select
cost-root
ap7131-11E6C4(config-device-00-23-68-11-E6-C4-meshpoint-test)#show context
meshpoint-device test
root select-method auto-mint
root-select cost-root
ap7131-11E6C4(config-device-00-23-68-11-E6-C4-meshpoint-test)#
Related Commands:
no
meshpoint-device-commands
Negates the commands for a meshpoint device or resets values to default
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
Syntax:
no [acs|exclude|hysteresis|monitor|path-method|preferred|root|root-select]
no acs [channel-hold-time|channel-switch-delta|channel-width|ocs-duration|
ocs-frequency|path-min|path-threshold|priority-meshpoint|sample-count|snr-del
ta|
signal-threshold|tolerance-period] [2.4GHZ|5GHz]
no exclude wired-peer mint-level-1
no hysteresis [min-threshold|period|root-sel-snr-delta|snr-delta]
no monitor [critical-resource|primary-port-link-loss]
no [path-method|root {select-method}]
root-select cost-root Configures this meshpoint device as the cost root. This is necessary for dynamic root selection
process.
no Removes this meshpoint-device as the cost-root