Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 339)

Brocade Mobility RFS Controller CLI Reference Guide 323
53-1003098-01
4
acl exceed-rate wireless-client-denied-traffic <0-1000000> {blacklist
<0-86400>|
disassociate}
Parameters
acl exceed-rate wireless-client-denied-traffic <0-1000000> {blacklist
<0-86400>|
disassociate}
Example
rfs7000-37FABE(config-wlan-test)#acl exceed-rate
wireless-client-denied-traffic
20 disassociate
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid test
bridging-mode tunnel
encryption-type none
authentication-type none
accounting syslog host 172.16.10.4 port 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
rfs7000-37FABE(config-wlan-test)#
answer-broadcast-probes
wlan-mode commands
Allows the WLAN to respond to probe requests that do not specify a SSID. These probes are for
broadcast ESS. This feature is enabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
answer-broadcast-probes
Parameters
None
acl exceed-rate Sets the actions taken based on an ACL rule configuration (for example, drop a packet)
•
exceed-rate – Action is taken when the rate exceeds a specified value
wireless-client-denied-traf
fic
<0-1000000> Sets the action to deny traffic to the wireless client when the rate exceeds the specified value
•
<0-1000000> – Specify a allowed rate threshold of disallowed traffic in packets/sec.
blacklist <0-86400> Optional. When enabled, sets the time interval to blacklist a wireless client
disassociate Optional. When enabled, disassociates a wireless client