Router – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1020
Brocade Mobility RFS Controller CLI Reference Guide
1011
53-1003098-01
15
Related Commands:
mtu
Configures global MiNT Multiple Transmission Unit (MTU). Use this command to specify the
maximum packet size, in bytes, for MiNT routing. Higher the MTU values, greater is the network
efficiency. The user data per packet increases, while protocol overheads, such as headers or
underlying per-packet delays remain the same.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
mtu <900-1500>
Parameters
mtu <900-1500>
Example
rfs7000-37FABE(config-mint-policy-global-default)#mtu 1000
rfs7000-37FABE(config-mint-policy-global-default)#show context
mint-policy global-default
mtu 996
level 2 area-id 2
rfs7000-37FABE(config-mint-policy-global-default)#
Related Commands:
router
Disables level 2 MiNT packet routing (inter-site packet routing)
<900-1500>
Specifies the maximum packet size from 900 - 1500 bytes
The maximum packet size specified is rounded down to a value using the following formula: 4 + a
multiple of 8.
The MTU setting specifies the maximum packet size used for MiNT packets. Larger packets are
fragmented to fit within the specified packet size limit. You may want to configure this parameter if the
MiNT backhaul network requires or recommends smaller packet sizes. The default value is 1500 bytes.
Reverts the configured MiNT MTU value to its default (1500 bytes)
Negates the configured maximum packet size for MiNT routing