Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1206)

1198 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
23
Related Commands:
retry-attempts
l2tpv3-policy-commands
Configures the maximum number of attempts made to retransmit signalling messages. Use this
command to specify how many retransmission cycles occur before determining the target tunnel
peer is not reachable.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
retry-attempts <1-10>
Parameters
retry-attempts <1-10>
Example
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#retry-attempts 10
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
hello-interval 200
retry-attempts 10
cookie-size 8
reconnect-interval 100
reconnect-attempts 8
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
Related Commands:
retry-interval
l2tpv3-policy-commands
no Resets the interval between successive attempts to re-establish a failed tunnel connection to default
(120 seconds)
retry-attempts
<1-10> Configures the maximum number of attempts made to retransmit signalling messages from 1 - 10
(default is 5 attempts)
no Resets the maximum number of retransmissions of signalling messages to default
(5 attempts)