Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1266)

1258 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
26
accounting server <1-2> host {secret [0 |2
|]} {port <1-65535>}
accounting server <1-2> timeout <3-5> {attempts <1-3>}
Example
rfs7000-37FABE(config-aaa-tacacs-policy-test)#accounting auth-fail
rfs7000-37FABE(config-aaa-tacacs-policy-test)#accounting commands
rfs7000-37FABE(config-aaa-tacacs-policy-test)#accounting server preference
authorized-server-number
rfs7000-37FABE(config-aaa-tacacs-policy-test)#show context
aaa-tacacs-policy test
accounting server preference authorized-server-number
accounting auth-fail
accounting commands
rfs7000-37FABE(config-aaa-tacacs-policy-test)#
Related Commands:
authentication
aaa-tacacs-policy
Configures user authentication parameters. Users are allowed or denied access to the network
based on the authentication parameters set.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
server <1-2> Configures an accounting server. Up to 2 accounting servers can be configured
host Configures the accounting server’s IP address or hostname
secret [0 |
2 |] Optional. Configures a common secret key used to authenticate with the accounting server
•
0 – Configures a clear text secret key
•
2 – Configures an encrypted secret key
•
– Specify the secret key. This shared secret should not exceed 127 characters.
port <1-65535> Optional. Configures the accounting server port (the port used to connect to the accounting server)
•
<1-65535> – Specify the TCP accounting port number from 1 - 65535. The default port is 49.
server <1-2> Configures an accounting server. Up to 2 accounting servers can be configured
timeout <3-5> Configures the timeout for each request sent to the TACACS accounting server. This is the time allowed to
elapse before another request is sent to the TACACS accounting server. If a response is received from the
server within this time, no retry is attempted.
•
<3-5> – Specify a value from 3 - 5 seconds. The default is 3 seconds.
attempts <1-3> Optional. Specifies the number of times a transmission request is attempted. This is the maximum
number of times a request is sent to the TACACS accounting server before getting discarded.
•
<1-3> – Specify a value from 1 - 3. The default is 3.
no Resets values or disables commands