Shutdown – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1289
Brocade Mobility RFS Controller CLI Reference Guide
1281
53-1003098-01
27
Related Commands:
shutdown
Shuts down this meshpoint. Use this command to prevent an AP from participating in a mesh
network.
Supported in the following platforms:
•
Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
•
Access Points (as root APs only) — Brocade Mobility 650 Access Point
•
Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
shutdown
Parameters
None
Example
rfs7000-37FABE(config-meshpoint-test)#shutdown
rfs7000-37FABE(config)
Related Commands:
use
Uses a Quality of Service (QoS) policy defined specifically for meshpoints. To use this QoS policy, it
must be defined. To define a meshpoint QoS policy, see
meshpoint-qos-policy-config-instance
Supported in the following platforms:
•
Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
•
Access Points (as root APs only) — Brocade Mobility 650 Access Point
•
Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
use meshpoint-qos-policy
Resets the restriction that only 802.11n capable neighbor devices can associate with this meshpoint
Invokes service commands to troubleshoot or debug
Enables an AP as a meshpoint