Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 247)

Brocade Mobility RFS Controller CLI Reference Guide 231
53-1003098-01
4
dns-whitelist
Global Configuration Commands
Configures a DNS whitelist. A DNS whitelist is a list of domains allowed access to the network.
The following table lists DNS Whitelist configuration mode commands.
dns-whitelist
dns-whitelist
Configures a DNS whitelist. A DNS whitelist is a list of domains allowed access to the network.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
dns-whitelist
Parameters
dns-whitelist
Example
rfs7000-37FABE(config)#dns-whitelist test
rfs7000-37FABE(config-dns-whitelist-test)#?
DNS Whitelist Mode commands:
no Negate a command or set its defaults
permit Match a host
clrscr Clears the display screen
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-dns-whitelist-test)#
Command Description Reference
dns-whitelist Creates a DNS whitelist and enters its configuration mode page 231
dns-whitelist-mode
commands Summarizes DNS whitelist configuration mode commands page 232
Specify the DNS whitelist name. If the whitelist does not exist, it is created.