Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 966)

Brocade Mobility RFS Controller CLI Reference Guide 955
53-1003098-01
13
option
dhcp-pool-mode commands
Configures raw DHCP options. The DHCP option must be configured under the DHCP server policy.
The options configured under the DHCP pool/DHCP server policy can also be used in
static-bindings.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
option [|]
Parameters
option [|]
Example
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#option option1
157.235.208.80
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#show context
dhcp-pool testPool
address 192.168.13.4 class dhcpclass1
ddns server 192.168.13.9
ddns multiple-user-class
excluded-address range 192.168.13.25 192.168.13.28
netbios-node-type b-node
dns-server 192.168.13.19
netbios-name-server 192.168.13.25
option option1 157.235.208.80
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#
Related Commands:
Sets the name of the DHCP option
Sets DHCP option as an IP address
Sets DHCP option as an ASCII string
NOTE
An option name in ASCII format accepts backslash (\) as an input but is not displayed
in the output (Use
show runnig config
to view the output). Use a double backslash to
represent a single backslash.
no Resets values or disables the DHCP pool option settings