Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1240)

1232 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
24
default-information originate {always|metric <0-16777214>|metric-type [1|2]}
{(metric <0-16777214>|metric-type [1|2])}
Example
rfs7000-37FABE(config-profile
default-rfs7000-router-ospf)#default-information originate metric-type 2
metric 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#show context
router ospf
area 0.0.0.4
auto-cost reference-bandwidth 1
default-information originate metric 1 metric-type 2
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
Related Commands:
ip
router-mode
Configures IP default gateway priority
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
ip default-gateway priority <1-8000>
Parameters
originate Originates default route information. Enabling this feature makes the default route a distributed route.
This option is disabled by default.
always Optional. Always distributes default route information (will continue to advertise default route information
even if that information has been removed from the routing table for some reason). This option is disabled
by default.
metric <0-16777214> This is a recursive parameter and can be optionally configured along with the metric-type option.
•
metric <0-16777214> – Optional. Specifies OSPF metric value for redistributed routes (this value is
used to generate the default route)). Specify a value from 0 - 16777214.
metric-type [1|2] This is a recursive parameter and can be optionally configured along with the metric option.
•
metric-type [1|2] – Optional. Sets OSPF exterior metric type for redistributed routes (this information
is advertised with the OSPF routing domain)
•
1 – Sets OSPF external type 1 metrics
•
2 – Sets OSPF external type 2 metrics
no Disables advertising of default route information available in the routing table