Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 671)

658 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
cdp
interface-config-instance
Enables CDP on the selected GE port
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
cdp [receive|transmit]
Parameters
cdp [receive|transmit]
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#cdp transmit
Related Commands:
channel-group
interface-config-instance
Configures a channel group
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
channel-group <1-4>
Parameters
channel-group <1-4>
transmit Enables CDP packet snooping on an interface
receive Enables CDP packet transmission on an interface
no Disables CDP on the controller or service platform’s selected GE ports
<1-4> Specifies a channel group number from 1 - 4