Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 768)

Brocade Mobility RFS Controller CLI Reference Guide 755
53-1003098-01
7
led {flash-pattern}
Example
rfs7000-37FABE(config-profile-Brocade Mobility RFS7000Test)#led flash-pattern
rfs7000-37FABE(config-profile-Brocade Mobility RFS7000Test)#
rfs7000-37FABE(config-profile-Brocade Mobility RFS7000Test)#show context
profile rfs7000 Brocade Mobility RFS7000Test
no autoinstall configuration
no autoinstall firmware
led flash-pattern
crypto ikev1 policy ikev1-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ikev2 policy ikev2-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ipsec transform-set default esp-aes-256 esp-sha-hmac
crypto ikev1 remote-vpn
crypto ikev2 remote-vpn
crypto auto-ipsec-secure
--More--
rfs7000-37FABE(config-profile-Brocade Mobility RFS7000Test)#
Related Commands:
led-timeout
Profile Config Commands
Configures the LED-timeout timer in the device or profile configuration mode
Supported in the following platforms:
• Service Platforms — Brocade Mobility RFS9510
Syntax:
led-timeout [<15-1440>|shutdown]
Parameters
led-timeout [<15-1440>|shutdown]
Example
nx9500-6C8809(config-device-B4-C7-99-6C-88-09)#led-timeout 25
flash-pattern Optional. Enables LED flashing on the device using this profile
Select this option to flash an access point’s LEDs in a distinct manner (different from its operational LED
behavior). Enabling this feature allows an administrator to validate an access point has received its
configuration (perhaps remotely at the site of deployment) without having to log into the managing
controller or service platform. This feature is disabled by default.
no Disables or reverts settings to their default
led-time [<15-1440>|
shutdown] Sets the LED-timeout timer. The value provided here determines the interval (time to lapse) for which a
device’s LEDs are turned off after the last radio state change. For example, if set at 15 minutes, the LEDs
are turned off for 15 minutes after the last radio state change.
•
<15-1440> – Specify a value from 15 - 1400 minutes.
•
shutdown – Shutsdown the LED-timeout timer. The device LEDs are not turned off.