Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 654)

Brocade Mobility RFS Controller CLI Reference Guide 641
53-1003098-01
7
environmental-sensor light radio-shutdown all
no autoinstall configuration
no autoinstall firmware
device-upgrade persist-images
crypto ikev1 policy ikev1-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ikev2 policy ikev2-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ipsec transform-set default esp-aes-256 esp-sha-hmac
crypto ikev1 remote-vpn
crypto ikev2 remote-vpn
--More--
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000)#
Related Commands:
events
Profile Config Commands
Displays system event messages
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
events [forward on|on]
Parameters
event [forward on|on]
Example
rfs7000-37FABE(config-profile-default-rfs7000)#events forward on
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
no Removes the environmental sensor’s settings
forward on Forwards system event messages to the wireless controller, service platform, or cluster members. This
feature is enabled by default.
•
on – Enables forwarding of system events
on Generates system events. This feature is enabled by default.
no Disables or reverts settings to their default