Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 752)

Brocade Mobility RFS Controller CLI Reference Guide 739
53-1003098-01
7
Configures a password for this WWAN interface. The configured value is used for authentication
support by the cellular data carrier.
Supported in the following platforms:
• Access Points — Brocade Mobility 71XX Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000
Syntax:
password [2 |]
Parameters
password [2 |]
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#password
TechPubsTesting@123
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#show
context
interface wwan1
password TechPubsTesting@123
crypto map test
ip nat inside
ip default-gateway priority 1
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
Related Commands:
use
interface-config-wwan-instance
Associates an IP ACL with this interface. The ACL should be existing and configured.
The ACL applies an IP based firewall to all incoming packets. The ACL identifies a single IP or a
range of IPs that are to be allowed or denied access on this interface.
Supported in the following platforms:
• Access Points — Brocade Mobility 7131 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000
Syntax:
use ip-access-list in
Parameters
2 Configures an encrypted password. Use this option when copy pasting the password from another device.
Enter the password string (should not exceed 32 characters in length.
no Removes the configured password