beautypg.com

Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 386

background image

370

Brocade Mobility RFS Controller CLI Reference Guide

53-1003098-01

4

Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point

Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000

Service Platforms — Brocade Mobility RFS9510

Syntax:

wlan-qos-policy

Parameters

wlan-qos-policy

Example

rfs7000-37FABE(config)#wlan-qos-policy test

rfs7000-37FABE(config-wlan-qos-test)#?

WLAN QoS Mode commands:

accelerated-multicast Configure accelerated multicast streams address assnd

forwarding QoS classification

classification Select how traffic on this WLAN must be classified

(relative prioritization on the radio)

multicast-mask Egress multicast mask (frames that match bypass the

PSPqueue. This permits intercom mode operation

without delay even in the presence of PSP clients)

no Negate a command or set its defaults

qos Quality of service

rate-limit Configure traffic rate-limiting parameters on a

per-wlan/per-client basis

svp-prioritization Enable spectralink voice protocol support on this

wlan

voice-prioritization Prioritize voice client over other client (for

non-WMM clients)

wmm Configure 802.11e/Wireless MultiMedia parameters

clrscr Clears the display screen

commit Commit all changes made in this session

do Run commands from Exec mode

end End current mode and change to EXEC mode

exit End current mode and down to previous mode

help Description of the interactive help system

revert Revert changes

service Service Commands

show Show running system information

write Write running configuration to memory or terminal

rfs7000-37FABE(config-wlan-qos-test)#

NOTE

For more information on WLAN QoS policy commands, see

Chapter 22, WLAN-QOS-POLICY

.

Related Commands:

Specify the WLAN QoS policy name. If the policy does not exist, it is created.

no

Removes an existing WLAN QoS Policy