Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 692)

Brocade Mobility RFS Controller CLI Reference Guide 679
53-1003098-01
7
ip address [|dhcp|zerconf]
ip address [ {secondary}|zeroconf {secondary}]
ip dhcp client request options all
ip nat [inside|outside]
ip ospf
[authentication|authentication-key|bandwidth|cost|message-digest-key|priority
]
ip ospf authentication [message-digest|null|simple-password]
ip ospf authentication-key simple-password [0 |2 ]
ip ospf [bandwidth <1-10000000>|cost <1-65535>|priority <0-255>]
ip ospf message-digest-key key-id <1-255> md5 [0 |2 ]
Parameters
ip helper-address
ip address [ {secondary}|dhcp|zerconf {secondary}]
ip dhcp client request options all
ip nat [inside|outside]
ip ospf authentication [message-digest|null|simple-password]
helper-address Enables DHCP and BOOTP forwarding for a set of clients. Configure a helper address on the VLAN interface
connected to the client. The helper address should specify the address of the BOOTP or DHCP servers. If you
have multiple servers, configure one helper address for each server.
•
– Specify the IP address of the DHCP or BOOTP server.
address Sets the VLAN interface IP address
{secondary} Specifies the interface IP address in the A.B.C.D/M format
•
secondary – Optional. Sets the specified IP address as a secondary address
dhcp Uses a DHCP client to obtain an IP address for this interface
zerconf {secondary} Uses Zero Configuration Networking (zerconf) to generate an IP address for this interface
•
secondary – Optional. Sets the generated IP address as a secondary address
dhcp Uses a DHCP client to configure a request on this VLAN interface
client Configures a DHCP client
request Configures DHCP client request
options Configures DHCP client request options
all Configures all DHCP client request options
nat [inside|outside] Defines NAT settings for the VLAN interface
•
inside – Sets the NAT inside interface
•
outside – Sets the NAT outside interface
ospf authentication Configures OSPF authentication scheme. Options are message-digest, null, and simple-password.
message-digest Configures md5 based authentication
null No authentication required
simple-password Configures simple password based authentication