Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 502)

488 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show mac-address-table {on }
Parameters
show mac-address-table {on }
Example
rfs7000-37FABE(config)#show mac-address-table on rfs7000-37FABE
--------------------------------------------------------
BRIDGE VLAN PORT MAC STATE
--------------------------------------------------------
1 1 ge1 00-02-B3-28-D1-55 forward
1 1 ge1 00-23-68-11-E6-C4 forward
1 1 ge1 00-A0-F8-68-D5-66 forward
1 1 ge1 5C-D9-98-4C-04-51 forward
--------------------------------------------------------
Total number of MACs displayed: 4
rfs7000-37FABE(config)#
macauth
show commands
Displays details of wired ports that have MAC address authentication enabled
For more information on enabling MAC address authentication on a wired port, see mac-auth .
Supported in the following platforms:
• Access Points — Brocade Mobility 6511 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
show macauth [all|interface|on]
show macauth [all|interface [|ge <1-5>|port-channel
<1-3>|up1]]
{(on )}
Parameters
mac-address-table Displays MAC address table entries
on Optional. Displays MAC address table entries on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.